Meyer MDV Series Instrukcja Obsługi Pobierz pdf (Strona 17)

INSTALLATION, OPERATING INSTRUCTION AND PARTS MANUAL

MDV SERIES

SPREADER OPERATION - SPREAD PATTERN

C. Material could freeze causing the unit to not

function correctly. Hopper should be emptied

and cleaned after each use.

DO NOT LEAVE UNUSED MATERIAL

IN HOPPER.

CAUTION!

B. Spread pattern / width depends on baffle settings

(Gas Engine / Hydraulic Drive 4ft-30ft.)

1. Internal baffle adjustments will move the spread

pattern to the right or left.

2. External baffle adjustments will block spreading

to the rear, right or left side.

GAS ENGINE DRIVE

A. Start engine and allow engine to warm-up to

operating tempeture and engage the clutch.

The amount of material spread, depends on

engine speed and gate opening. Decreasing

RPM and/or gate height will decrease amount

spread. The inverse also holds true. Notice

that the electric clutch can be engaged or

disengaged at any time and at any engine

RPM. However, since engagement time and

torque is almost instantaneous, to prevent

premature spinner chain failure and chain

tension loss, it is recommended that the

electric clutch be engaged at the lowest

possible RPM without stalling the engine.

NOTE: If the truck is to be driven for an

extended period of time while the spreader is

not operating, it is RECOMMENDED the gas be

turned off at the fuel tank shut-off valve to

prevent the carburetor from over filling with

fuel.

ALWAYS STAND AT A SAFE DISTANCE AWAY

FROM THE SPINNER WHILE OPERATING.

ALWAYS WEAR EYE PROTECTION WHEN

OUTSIDE OF THE TRUCK CAB WHILE

SPREADER IS RUNNING.

WARNING!

3       NOVEMBER 

PAGE 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 75 76

Komentarze do niniejszej Instrukcji

Brak uwag

Meyer MDV Series Instrukcja Obsługi Strona 17

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Rozszerzacz Meyer MDV Series